Recalibrate Laptop Battery
A laptop battery is a vital component of a portable computer, as it provides the power needed to run the system when not connected to a power outlet. Over time, however, a laptop battery's capacity may decrease, resulting in shorter battery life and the need for more frequent charging. In this article, we will provide a step-by-step guide on how to recalibrate a laptop battery in Windows 10.
 |
| Laptop Charging |
Before we start, it is important to note that recalibrating a laptop battery involves completely draining and recharging the battery, which can take several hours. Therefore, it is recommended to perform this process when you have plenty of time and can leave your laptop plugged in for an extended period.
Step 1: Fully Charge the Battery
The first step in recalibrating a laptop battery is to fully charge the battery. To do this, connect your laptop to a power source and allow the battery to charge to 100%. You can monitor the battery's charging progress in the system tray, which is located on the bottom right corner of the screen.
Step 2: Disable Hibernation
The next step is to disable hibernation. Hibernation is a power-saving mode that saves the current state of the system to the hard drive and then shuts down the computer. It is recommended to disable hibernation during the recalibration process to prevent the battery from entering hibernation mode during the discharge cycle.
To disable hibernation, open the Command Prompt as an administrator. You can do this by pressing the Windows key + X and selecting "Command Prompt (Admin)" from the menu.
In the Command Prompt window, type "powercfg.exe /hibernate off" (without the quotes) and press Enter. This will disable hibernation on your laptop.
Step 3: Drain the Battery
Once you have fully charged the battery and disabled hibernation, you can start the discharge cycle. To do this, unplug your laptop from the power source and use it normally until the battery is completely drained. You can monitor the battery's discharge progress in the system tray.
Note: It is recommended to use the laptop normally during the discharge cycle and avoid any power-saving modes, such as sleep or hibernation.
Step 4: Charge the Battery Again
After the battery has been completely drained, connect your laptop to a power source and allow the battery to charge to 100%. You can monitor the battery's charging progress in the system tray.
Step 5: Re-enable Hibernation
Once the battery is fully charged, you can re-enable hibernation. To do this, open the Command Prompt as an administrator and type "powercfg.exe /hibernate on" (without the quotes) and press Enter. This will re-enable hibernation on your laptop.
Step 6: Verify Battery Calibration
To verify that the battery has been recalibrated, you can use the built-in Battery Report feature in Windows 10. To generate a battery report, open the Command Prompt as an administrator and type "powercfg /batteryreport" (without the quotes) and press Enter. This will generate a report that includes information about your laptop's battery, including its current capacity and charge cycles.
Conclusion
Recalibrating a laptop battery in Windows 10 can help improve the accuracy of the battery's power level indicator and restore its original capacity. However, it is important to note that the effectiveness of this process may vary depending on the age and condition of the battery. If you continue to experience issues with your laptop battery after recalibrating it, it may be time to replace the battery.
Do not forget to share your opinion in the comments section and also join us on the social networking sites to stay connected with us.